- Technical Specifications

Bridge Wire Resistance: 0.7+0.2
No-Fire Current: 0.35 A
All-Fire Current: 1.6 A
Safe Testing Current: 20mA
Application Temperature: -40C ~ 80C
Clip Material: ABS
Clip Dimension: 40x15x10mm
Leg Wire Length: 3M
Leg Wire Resistance: 0.4
Leg Wire Core Material: Copper
Leg Wire Core Diameter: 0.5mm
Leg Wire Insulation Material: PVC
Leg Wire Dimension: 1.2x2.4mm

- Solar Flare Igniters

Tested by the Canadian Government Explosives Research Laboratory, electrical connectors have been approved for shipping and storage while attached to CAT 3 and 4 display fireworks.

Updated in 2010 with a secondary heating coil and protective coating, are completely reliable and a viable alternative to pyrogen Igniters. are also exempt from the forthcoming requirements of CE marking within the European Union

are easy to install to quick match in a virtually risk free environment. Many Companies are changing to this innovative and reliable pyrogen free igniter.

contain no pyrogen material yet burn at 1200 celsius. No risk from static, compression or friction.

Tried and tested on all leading firing systems, perfectly suited to choreographed shows.

This video clip shows two PyroSure modules firing 24 SFI each at 0.5 sec intervals. The timings are accurate and without any delay.

How To Use Solar Flare Igniters

Make a straight cut on quick match. Create a space between black match and paper cover. DO NOT insert clip between two layers of paper. Insert the lower jaw of the igniter between paper and black match.

Ensure the black match is in direct contact with internal green PCB. Slide the Quick match over lower jaw of clip until fully seated against shoulder. Do not close by squeezing end of clip.

Hold clip firmly and squeeze where PCB is visible as indicated locking each side in turn 1 then 2.